Manufacturing Engineer (Santiago de Querétaro)

Manufacturing engineer - Project and Integration specialist

Responsible for project planning, supplier management, and integration execution for the small scale area in our Querétaro plant.

Ramp up

• Monitor productivity and improve and stabilize manufacturing KPIs (Technical Availability, Reject Rate, Scrap, Downtime, CPKs, Cycle time).
• Support activities to address safety, quality, and productivity for the assigned manufacturing processes using tools such as 5-why, Shainin, 8D, Six Sigma, DOE, 6S, SCIP, PDCA.
• Start process-FMEA, frame and release for a handover to the receiving manufacturing engineer.
• Execute FMEA Line-walk and error simulation to be strongly linked and aligned with CP guidelines.
• Develop, maintain, and support procedures, instructions and training material (PQI, CO, CP Dummy Part/Red Rabbit Documentation).
• Definition of measures for closing the target gap for Value Engineering (VA) and implementation (Cost Engineering & Benchmarking).

Planning

• Design, planning, and development of manufacturing sequences and operations, equipment and resources.
• Define, acquire, transfer, accept, validate, release and install production processes and equipment according to Bosch standards (integrations on line, new projects, participate in QGCs, Design for Manufacturing).
• Plan and develop new manufacturing sequences and operations and participate in implementing engineering and process change requests.
• Coordinate implementation and further development of manufacturing technologies in the GB across sites and active exchange of lessons learned (complaints, equipment, processes...) from other and to other Value Stream and IPN plants.
• Execute the quality planning (definition of test strategies, test methods, verification of measure and test process qualification, test data management, Q-control cycle series production).
• Document the quality planning.
• Project planning from kickoff to handover to production execution.

Qualifications

• Bachelor's degree in mechanical engineering, plastics engineering, manufacturing engineering, industrial engineering or similar.
• At least two years of experience developing manufacturing methods, procedures, processes in a production environment.
• Knowledge about safety practices and inspections.
• Experience with continuous improvement, lean principles, and value stream mapping in a manufacturing environment.
• Experience with 3D CAD systems.
• Project experience in planning and supplier management for integration projects.